"Blessed." JDM car sticker for the windshield or rear window

"Blessed." JDM car sticker for the windshield or rear window – vinyl car sticker

The "blessed." JDM car sticker is ideal for the windshield or rear window and gives your vehicle a stylish, clean look. Perfect as a JDM car sticker, window sticker, or car decal for tuning and car styling enthusiasts.

The sticker is resistant to most cleaning agents.
Furthermore, the sticker is resistant to steam cleaners, car washes, etc.
The sticker is temperature resistant between -50°C and +120°C.
Outdoors, the product has a lifespan of up to 8 years (depending on the color).
Indoors, the sticker has virtually unlimited durability.

The stickers are contour cut, meaning that only the letters or logo are visible on the object afterwards.
After the cutting process, the stickers are covered with a special transfer film to allow for easy application.


Instructions for optimal installation:

1. Clean the desired area with a grease-free solution. (Use a surface cleaner or silicone remover.)

2. Bonding should never be carried out at ambient temperatures below +10°C (if necessary, heat the desired area beforehand with a hot air gun). After bonding, the ambient temperature should not fluctuate significantly for approximately 72 hours.

3. Slowly peel off the backing paper of the sticker. Make sure that all parts of the sticker are picked up from the transfer film.

4. Stick the sticker to the desired location and rub over the sticker several times with pressure to ensure perfect adhesion.

5. Slowly peel off the front of the sticker (transfer film) and remove it from the backing sheet at a 180-degree angle. If the design remains stuck to the transfer film, back off slightly, smooth the film again, and continue the peeling process.


All measurements are approximate and may vary by a few millimeters.